Expension Joint Repairing

EXPANSION JOINT REPAIRING

A multi purpose sealant and gap filler based on special polymers, after curing through moisture evaporation, it forms and attractive joint sealant.New eversmatic is very easy to apply to fill the gaps and joints subject to a limited amount of movement, such as pre-cost concrete panels around the doors and windows, fixture and fillings. Naturally occurring joints between different building materials, wall’s and roofs surface cracks.New eversmatic: is ready for use and economical jointing compound with the following beneficial properties, ready to use no further mixing is required. Smooth attractive finish, excellent adhesion to most materials. even though with low inherent strength and color stable, can be over painted easily, odours free, type special polymer. Shelf life 1 year. when unopened and store correctly in dry and cool area. cure rate: full cure-approximately 1 week (depending on climate). Movement capacity 24-45% of average joint width minimum joint depth 6mm. Maximum joint width 25mm
width depth ratio upto 10mm wide = 1:1 for joints from l0 mm—25mm2:1 coverage 10 rft kg 1x1x1 surface preparation all surfaces must be clean and free from all loose adhering particles, porous materials may be slightly damp.

Walls/roofs surface cracks over 1.5mm in width must be ground in general no primer is required. Very absorbent substrates may be primed with a mixture of a part new evermastic and 4part of water apply by brush one thin uniform coat.
New evermastic is easy applied direct from the using the normal spatula, clean all tools and equipment immediately after use with clean water.
1. Do not use on soft plastics, bare metal, bitumen or tar.
2. Unsuitable for underwater joints if the sealant is not used within the recommendations.
Have then consulted our technical department.
Supply packing: sokgs-60kgs-7okgs-8

EXPANSION JOINT REPAIRING

Leave a Reply

Your email address will not be published. Required fields are marked *